PCem Cirrus Logic SVGA emulation planar support enabled.Makes booting noticeably quicker on OS39 and newer KS versions if mainboard IDE is not needed. Epson printer emulation does not anymore print each page as a separate document.Keyboard key (if non-qualifier key) presses are released immediately in warp mode.
It is now possible to type (almost) normally in warp mode.uaegfx Picasso96 overlay now works correctly with screen dragging.Programmed display mode improvements (positioning, blanking etc).Paula configured for 4us (GCR) mode but normal 2us MFM disk in drive: disk index reporting was unreliable.
#Amiga system roms winuae software#
Software YUV based filters had bad colors (32-bit only). NTSC mode and software switch to PAL: display was incorrectly vertically stretched. Integer scaling only worked correctly if horizontal (lores, hires, superhires) and vertical resolution (non-doubled, doubled) matched.Filtered lores had wrong colors if host graphics mode was 16-bit. Mouse would start moving erratically if emulator has been running continuously more than 10 hours. WinUAE message: Could not load system ROM, trying system ROM replacement. Custom chipset and programmed display mode updates and fixes. WinUAE message: One of the following system ROMs is required: KS ROM v1.3 (A500,A1000,A2000) rev 34.5 (256k) 315093-02 KS ROM v1.3 (A3000)(SK) rev 34.5 (256k) Check the System ROM path in the Paths panel and click Rescan ROMs. Remove interlace artifact option added 1 scanline offset to bitplanes and sprites. PCem RTG board 15 and 16-bit lores modes didn’t horizontally double correctly. x86 AT bridgeboard (A2286 and A2386SX) boot crash. 
JIT enabled + emulated (not uaegfx) RTG board corruption was possible in certain situations.Demnächst dann auch hier zum Download! Die Änderungen: Der Amiga-Emulator WinUAE wurde heute in der Version 4.9.1 veröffentlicht.
0 kommentar(er)
